This site will look much better in a browser that supports web standards, but it is accessible to any browser or Internet device.

WorkSafeBC

banner image

Investigation Reports - Primary Resources


Construction | Manufacturing | Primary Resources | Public Sector | Service Sector | Trade | Transportation & Warehousing

Operator dies in skidder rollover
Date of incident: July 2007
NI number: 2007136900128
Send to a Friend

A colleague pointed out that chainsaws are sometimes carried beside the seat in a skidder, so it's possible the seat belt was melted by the hot muffler of a chainsaw. more
Summary
A grapple skidder was across the hill on a 40% slope. It became unstable on a narrow bench of land that was the upper portion of the cable yarding area. The skidder rolled over twice on the bench land and then it continued to roll many more times down much steeper terrain. The seat belt had previously been damaged and it tore in half during the incident. The skidder operator sustained fatal injuries.

Conclusions

Findings as to causes
  • The skidder lost stability on a 40% slope. The sudden destabilizing event resulted in a rapid shift of weight distribution and quickly changed the skidder's centre of gravity and surface traction. Once the machine became unstable, the skidder operator could not restore the skidder's stability or stop the multiple-rollover incident from continuing.
Findings as to underlying factors
  • Operating the skidder across the slope created an increased potential for machine instability.
  • The skidder was working on a 40% slope at the time of the rollover. There were no written safe work procedures regarding rubber-tired skidders operating on slopes greater than 35%.
  • The skidder was working in close proximity to very steep terrain as it was on a bench next to a steep hill with a 65-79% slope. Although this was not a factor in the initial loss of stability causing the rollover, the steep hill contributed to the continuation of the rollover and the severity of the incident.
  • The seat belt failed during the incident because of previous damage. It is not known whether the skidder operator would have survived the rollover if the seat belt had remained intact.
LINKS:

Hazard Alert: http://www2.worksafebc.com/publications/posters.asp?reportID=35197

Audio Slide Show: http://www2.worksafebc.com/Publications/Multimedia/slideshows.asp?ReportID=35280

Optional: Yes No

Please share your feedback

Investigation (or slideshow) title: Operator dies in skidder rollover

Yes No



You can return to the Top of this page